As with most of my projects, the search for the right materials without resorting to a visit to the local hardware store results in some time passing before I have everything I need to finish a job.
Recently I was fortunate enough to get together the final bits and pieces (and a helping hand from my sister’s boyfriend) I needed to build a stand for my water tank and connect it to my shed.
I already had the tank and had given it a good rinse, bought second hand from a local. I’d been given a heavy duty plastic pallet which could handle the weight of a full tank of water. And recently I sourced some sleepers from the in-laws property, and some plumbing supplies from the local tip shop.
And alas, the tank is now set up and, after some decent rain, is full and being put to good use.
The tank is set up from the ground so that my watering can can fit under the tap, and to also use gravity to force the water out at a reasonable rate without using a pump. The faucet has a hose connector attached to it to make for easy watering.
The bottom level of the stand is made up with the three sleepers making up the border, with sleepers screwed in inside the box to support the plastic pallet and the tank. The pallet is sitting on top of the enclosed bottom level sleepers, with another three sleepers screwed together to make a border around the pallet to keep it in place.
The resulting stand, I think, looks pretty good and a does a great job!
Plumbing the tank wasn’t as difficult as I thought it might. I pulled the down pipe which connects the gutters to the drain out and using some existing pipe elbows and some found at the tip shop, re-routed the rainwater out from behind the shed, along the side of the shed and into the inlet hole.
All it takes is some good measurements, and the simple understanding that water can’t run up – you can see from the pipe attached along the side of the shed that it is on a slight angle down to ensure that the water runs properly down into the tank.
Finally, I’ve added another pipe to the overflow outlet, which currently runs into a big old pot. The idea will be to find another container for this overflow to run into, possibly an old wheelie bin which can then be adapted with a tap to allow this to be used as a portable water source.
The project wasn’t as daunting as I thought it might be, and would encourage anyone to have a go at it. Even if it isn’t with recycled materials, hardware stores carry equipment to divert rainwater from downpipes so that it can stored and used when needed. And of course it adds a further degree of sustainability to your garden and, in my case, to my growing veggies. Even a small roof area can collect a usable amount of water.
I am blessed by the fact that the gutters installed on the shed roof are constructed in a way to stop leaves and other objects from flowing down into the downpipes. For a normal gutter, it would be best to put some shade cloth or other gauze like material to trap leaves and dirt from running into the tank.
Although I haven’t done it yet, I’m planning on adding something to the pipes to catch smaller object from falling into the tank, with the idea of being able to use the tank water (after testing it properly of course) as drinking water.
I’d love to hear any stories or suggestions from people who have done the same thing, or are planning on doing so.